Slat care liquid
The protective shield for your slats
Keep slag under control
The new slat care liquid maximises the service life of your slats. This innovative product forms a protective layer on the slats, significantly reducing the build-up and adhesion of slag. Slat care liquid is suitable for all standard cutting materials and works reliably on both mild steel and copper slats. However, slat care liquid has no effect on downstream processes.
The thin protective film acts as a barrier between the slat and the slag
Significantly reduced slag formation and residue build-up
Thanks to less residue on the slats cleaning is noticeably easier
Suitable for all common cutting materials
No impact on downstream processes
Slat care liquid & spray gun
Videos
Application
How to use the product correctly
Product focus
Discover the product and its benefits
The ideal combination
Slat care liquid & slat cleaner
Reduced costs: slat service life up to 4 times longer
More efficient cleaning with the slat cleaner. Less time and effort required
Consistently high part quality and process reliability due to reduced slag content
Less splatter on the rear of the components
Frequently asked questions: Scope of application
Slat care liquid is suitable for 2D laser cutting machines (fibre and CO2), regardless of the manufacturer. The protective effect has been successfully tested on various lasers with a laser power of up to 30,000 W .
No, slat care liquid is intended as a supplement to the slat cleaner. Slag formation and adhesion is significantly reduced by the spraying agent , which makes the cleaning process using a slat cleaner faster and easier .
Slat care liquid is designed exclusively for spraying the slats of 2D laser cutting machines .
Slat care liquid has been successfully tested on slats made of mild steel and copper. The test results show reliable protection of both materials.
Tests have shown that the recoating process was not adversely affected.
Wearing PPE (protective gloves, safety glasses, breathing mask) is recommended.
Frequently asked questions: Application
For optimal spraying results, we recommend using the TRUMPF compressed air spray gun
Note:
These dosage recommendations should be considered guidelines and are based on optimal conditions for even application. Adjust the quantity according to your needs and conditions.
Apply slat care liquid at least once a week to mechanically cleaned or new slats. Adjust the frequency according to your needs and conditions.
Yes, spray the slats with slat care liquid again after each mechanical cleaning
You can begin the cutting process immediately after spraying .
Note:
The time between spraying and the actual cutting should be no more than 2 days. If this time window is exceeded, the effectiveness of the spray may be adversely affected
Frequently asked questions: Storage
Store the product at room temperature somewhere dry and clean, protected from light and frost.
When stored properly in the original, sealed container, the product has a shelf life of at least 24 months.
