We use cookies for this website. If you continue to use this website without changing the settings for cookies, we assume that you agree to the use of cookies.

Spot welding and seam welding with lasers

Technology-Picture-laser-welding-machines

With laser welding, you can create single joining spots or weld in continuous wave mode. The weld geometry describes how the parts fit together. For example, they may overlap or butt up against each other. The mechanical properties are the first thing to consider when defining the weld geometry.Is a continuous weld required, or will the weld consist of individual welding spots? Is the weld made up of a large number of short lines or lots of small circles? Here, too, the decision of which type of weld to use depends on two important factors: the required strength of the weld and the maximum amount of heat input into the component.

Different kinds of joints require different operation modes of the laser device.

Continuous wave mode

In this mode the laser medium is pumped continuously and emits a continuous laser beam.

Pulsing

In pulsed mode, the gain medium is pumped in bursts to generate short laser pulses. Power, duration and frequency of the laser pulses are important parameters for material processing.

Products

TruPulse
TruPulse

Pulsed peak power in the multi-kilowatt range for spot welding and seam welding

TruFiber 1000
TruFiber

Precision laser for delicate work

TruDisk, Höchstleistung aus der Scheibe
TruDisk

Maximum performance from the disk

TruDiode, der energieeffiziente Diodenlaser
TruDiode

The energy-efficient diode laser

TruLaser Station 5005, der einfache Einstieg ins Laserschweißen
TruLaser Station 5005

The easy way to start with laser welding

Contact

Sales
Fax: +91 20 6675 9899
E-mail
Service & contact